mtk-20170518/package/base-files/files/lib/preinit, branch master

merge: base: update base-files and basic config

2017-12-08T18:41:18+00:00

Signed-off-by: Zoltan HERPAI

base-files: drop unused preinit_echo function

2017-08-09T21:23:06+00:00

It isn't used for years since the old 99_10_run_init has been dropped.

Signed-off-by: Rafał Miłecki

base-files: don't setup network in preinit if failsafe is disabled

2017-08-09T21:18:59+00:00

With failsafe disabled there is no point in early network setup. We
don't send announcement over UDP and there is no way to ssh to the
device.

A side effect of this is avoiding a possibly incorrect network config
(only with failsafe disabled). This problem is related to possible
changes made by user in /etc/config/network.

Signed-off-by: Rafał Miłecki

treewide: populate boardname and model earlier

2017-07-15T21:13:34+00:00

For targets using the generic board detection and board specific
settings in diag.sh, the board name is still unset at the time the
set_state() provided by diag.sh is called by 10_indicate_preinit.

Change the execution order to ensure the boardname is populated before
required the first time. Do the target specific board detection as
early as possible, directly followed by the generic one to allow a
seamless switch to the generic function for populating /tmp/sysinfo/.

Signed-off-by: Mathias Kresin

base-files: board.json's switch reset means existence, not argument

2017-06-11T10:50:14+00:00

Don't pass the value unconditionally to swconfig as a parameter but
instead only call reset if it is 1.

Signed-off-by: Jonas Gorski

base-files: add support for staged sysupgrades from failsafe mode

2017-05-29T21:50:33+00:00

Signed-off-by: Matthias Schiffer

base-files: don't overwrite model name set by target

2017-01-30T07:55:41+00:00

The condition is always true due to the literal string followed the
-n test parameter. A model name set by target scripts always gets
overwritten this way.

Change the condition to check for an already existing destination file
as it was before 5e85ae9 ("base-files: fix error message during boot").

Signed-off-by: Mathias Kresin

base-files: set pi_ifname in board.d case to fix deconfig

2016-08-14T21:10:17+00:00

Due to an empty pi_ifname in the generic failsafe setup, the deconfig
never removed the failsafe networking interface, causing broken
networking later on.

Signed-off-by: Jonas Gorski

base-files: configure switch in failsafe

2016-08-13T13:50:15+00:00

Also configure the switch based on the failsafe config, and create the
failsafe interface as tagged if necessary.

Signed-off-by: Jonas Gorski

base-files: allow failsafe to configure vlans

2016-08-13T13:50:06+00:00

In preparation of properly setting up vlans and switches, add
support for configuring failsafe on a vlan tagged interface.

Signed-off-by: Jonas Gorski