mtk-20170518/target/linux/bcm53xx, branch master

kernel: bump 4.14 to 4.14.67

2018-08-28T21:05:39+00:00

Refreshed all patches.

Removed upstreamed patches:
- 037-v4.18-0008-ARM-dts-BCM5301x-Fix-i2c-controller-interrupt-type.patch

Compile-tested on: cns3xxx, imx6
Runtime-tested on: cns3xxx, imx6

Signed-off-by: Koen Vandeputte

kernel: bump 4.14 to 4.14.59

2018-07-31T02:11:07+00:00

Drop patch that was superseded upstream:
ramips/0036-mtd-fix-cfi-cmdset-0002-erase-status-check.patch

Drop upstreamed patches:
- apm821xx/020-0001-crypto-crypto4xx-remove-bad-list_del.patch
- apm821xx/020-0011-crypto-crypto4xx-fix-crypto4xx_build_pdr-crypto4xx_b.patch
- ath79/0011-MIPS-ath79-fix-register-address-in-ath79_ddr_wb_flus.patch
- brcm63xx/001-4.15-08-bcm63xx_enet-correct-clock-usage.patch
- brcm63xx/001-4.15-09-bcm63xx_enet-do-not-write-to-random-DMA-channel-on-B.patch
- generic/backport/080-net-convert-sock.sk_wmem_alloc-from-atomic_t-to-refc.patch
- generic/pending/170-usb-dwc2-Fix-DMA-alignment-to-start-at-allocated-boun.patch
- generic/pending/900-gen_stats-fix-netlink-stats-padding.patch

In 4.14.55, a patch was introduced that breaks ext4 images in some
cases. The newly introduced patch
backport-4.14/500-ext4-fix-check-to-prevent-initializing-reserved-inod.patch
addresses this breakage.

Fixes the following CVEs:
- CVE-2018-10876
- CVE-2018-10877
- CVE-2018-10879
- CVE-2018-10880
- CVE-2018-10881
- CVE-2018-10882
- CVE-2018-10883

Compile-tested: ath79, octeon, x86/64
Runtime-tested: ath79, octeon, x86/64

Signed-off-by: Stijn Tintel

bcm53xx: revert SPI controller commit breaking flash reads

2018-07-29T09:02:57+00:00

That upstream commit caused instability in flash reads. It was reported
but there isn't any proper fix as for now.

Signed-off-by: Rafał Miłecki

bcm53xx: backport BCM5301X/BCM53573 dts commits from 4.19+

2018-07-28T19:48:10+00:00

This includes Linksys EA9500 support, BCM53573 timer fix and
upstream-ready partitions patch that replaces two downstream hacks.

Signed-off-by: Rafał Miłecki

bcm53xx: switch USB 3.0 PHY DT description to use MDIO bus

2018-07-28T19:46:08+00:00

USB 3.0 PHY is attached to the MDIO bus and should be supported
(accessed) as a MDIO device. This wasn't known initially which resulted
in writing driver that was working with MDIO bus (using some magic
values) without knowing it.

This commit updates DT to properly describe MDIO & USB 3.0 PHY and
enables required kernel drivers.

Signed-off-by: Rafał Miłecki

bcm53xx: backport DT fix for I2C controller interrupt

2018-07-28T19:36:33+00:00

Specified interrupt type was incorrect.

Signed-off-by: Rafał Miłecki

kernel: backport mtd patches with Broadcom of_match_table-s

2018-07-27T13:55:01+00:00

Two tiny & trivial patches with no regression risk. One simplifies
bcm53xx downstream patch.

Signed-off-by: Rafał Miłecki

bcm53xx: exit if writing kernel during sysupgrade fails

2018-06-18T11:47:08+00:00

Signed-off-by: Rafał Miłecki

bcm53xx: drop not ready support for Luxul devices

2018-06-18T06:46:23+00:00

Support for these devices isn't ready yet and it was only accidentally
pushed in the commit 0da9303e5b44 ("mac80211: backport "brcmfmac:
cleanup and some rework" from 4.17").

Signed-off-by: Rafał Miłecki

mac80211: backport "brcmfmac: cleanup and some rework" from 4.17

2018-06-17T20:46:29+00:00

It was described by Arend as:

> This series is intended for 4.17 and includes following:
>
>  * rework bus layer attach code.
>  * remove duplicate variable declaration.

Signed-off-by: Rafał Miłecki