mtk-20170518/target/linux/brcm47xx/base-files/lib/preinit, branch mtk-20170518

target/linux : drop many arch

2018-09-14T20:25:09+00:00

brcm47xx: fix network failsafe indication

2014-01-12T18:56:15+00:00

Remove the code used on the old switch driver.
The Ethernet drive is loaded as a module and needs some time to get up
therefor we added some wait function.

Signed-off-by: Hauke Mehrtens 

SVN-Revision: 39254

brcm47xx: fix switch handling

2013-07-14T13:19:58+00:00

This fixes some problems with the switch handling

 * It now send the messages again to indicate a button for failsafe mode should be pressed
 * it does not leak packages between wan and lan any more
 * the switch works again in normal mode

The Ethernet connection has to be up when the switch driver switch-robo
is insmoded therefor we just do it again.
Explicitly set enable_vlan to prevent leaking packages.

This should close #13869, #13868 and #13716

SVN-Revision: 37286

brcm47xx: do not load the kernel modules needed for Ethernet manually

2013-07-14T12:59:00+00:00

add the boot flag to make the kernel modules needed for Ethernet and
diag load on startup.

SVN-Revision: 37284

brcm47xx: do not change nvram without user interaction

2013-07-14T12:56:42+00:00

SVN-Revision: 37281

brcm47xx: proc gets mounted without this patch

2013-07-13T21:42:19+00:00

SVN-Revision: 37272

brcm47xx: remove obsolete hotplug stuff

2013-07-13T20:38:33+00:00

SVN-Revision: 37271

brcm47xx: dont manually insmod switch drivers

2013-06-21T16:53:15+00:00

Signed-off-by: John Crispin 

SVN-Revision: 36993

brcm47xx: do not use vlan0 any more.

2013-02-20T15:31:43+00:00

The Broadcom switch driver says that vlan0 should not be used with any switch other than bcm5325.

This makes OpenWrt always use vlan1 and vlan2 instead.

SVN-Revision: 35704

brcm47xx: improve cpuport detection for filesafe

2013-02-16T16:24:15+00:00

Do not try to load bcm57xx.ko any more this is not needed for kernel 2.6 and 3.X
Ask the switch driver where the CPU port is.

SVN-Revision: 35624